Triton RT2000 Installation Manual - Manual (Page 31)

31
I
NSTALLING
C
ABINET
T
HROUGH
W
ALL
O
PENING
1. Carefully inspect the unit for any
shipping damage and report any
damage immediately to the
shipping company. Refer to the
warranty information in the
operation or service manual (as
applicable) for information about
reporting shipping damage.
2. After unpacking the unit (see
warning) ,carefully move the
cabinet using the proper lifting/
moving device to the wall opening.
3. Slide the unit up to the opening
until the sleeve portion of the
cabinet is near the wall
4. Measure the distance from the
bottom of the wall opening to the
bottom of the sleeve. This will
be the height requirement needed
to install the unit through the wall
opening. Add an additional 1/2”
(12.7mm) to your measurement
for clearance (Figure 1).
*** WARNING ***
The RT2000 unit is top heavy.
USE EXTREME CAUTION!
Always move/support the unit
from the FRONT! 2-personnel
are recommended when
unpacking and moving the
unit!!
* IMPORTANT *
DO NOT install the control
panel trim at this time.
Figure 1. Measure from bottom of
wall opening to bottom of sleeve.