Triton 9200 Operation Manual - Manual (Page 159)

6-5
T
RITON
S
YSTEMS
, I
NC
.
S
ECTION
6 - M
AINTENANCE
M
ODEL
9200 S
UPER
S
CRIP TM O
PERATION
M
ANUAL
6. Place the paper roll and paper spool back on the paper bracket by sliding the small slotted
end of the spool into the large hole in the bracket as shown in Figure 6-6A. Push the paper
and spool into the operating position to lock them in place as seen in Figure 6-6B.
7. Once the paper roll and spool are installed
on the paper bracket, take the end of pa-
per roll and feed it into the printer path
paper entrance. Refer to Figure 6-7.
8. Once the paper is fed into the paper path
entrance, the printer will activate and au-
tomatically feed the paper through the
printer and out the exit.
9. Close and lock the SuperScrip Terminal.
Figure 6-6A. Placing the paper roll and
spool on the paper bracket. Figure 6-6B. Paper roll and spool in
place for operation.
Figure 6-7. Feeding paper into the printer.
Insert end of paper here.