Triton ARGO Installation Manual - Manual (Page 19)

19
ARGO I
NSTALLATION
M
ANUAL
I
NSTALL
S
TANDARD
A
NCHORS
/
B
OLT
ATM
TO
F
LOOR
L
OCKING
N
UT
F
LAT WASHER
ARGO ATM B
ASE
A
NCHOR
B
OLT
M
OUNTING
N
UT
Anchor bolt installation illustration
S
LAB
Anchor Bolt
1. Ensure the mounting location is free of all debris that might cause the
cabinet to not be level. Use blower or vaccuum to remove any dust or
particles.
2. Move the ATM into position for mounting by aligning the base over the
four holes drilled in the previous procedure.
3. Place an anchor bolt through the cabinet base and into one of the
mounting holes. Use a ball peen hammer to tap the bolt completely into
the hole.
IMPORTANT: If the anchor bolt “falls” into the hole without being
tapped in, the hole is too large! Move the mounting hole pattern and
redrill using smaller holes as necessary to achieve a snug fi t.
4. Place a fl at washer on the anchor bolt followed by a 1/2” (13mm) nut.
Do not tighten fully, allow for leveling.
5. Repeat Steps 3 and 4 for the remaining anchor bolts.