Tilton Firewall-Mount (98-1205) - Manual (Page 3)

balance bar aDjustMent
Fixed position - If a remote adjuster will not be used remove the set screw
in the right end of the balance bar and snug the balance bar locking nut
up against the right clevis pivot. Only one locking nut is required.
Remote Cable Adjuster - The right end of the balance bar has been
drilled to accept the remote adjuster cable directly. No coupler is required.
Slip the end of the cable into the end of the balance bar and tighten the
setscrew.
Right Angle Adjuster - To solve cable routing problems use right angle
adjuster part number 72-561. This is a small protected bevel gear drive
unit that will allow the cable to approach the balance bar at a 90 degree
angle.
ports
Inlet: –6AN, crush washer seal. Connection fittings (-6AN crush washer to
-4AN male taper) are sold spearately, avilable from Tilton (P/N 77-015).
Comparable Goodridge fittings are acceptable as well.
Outlet: –3AN, crush washer or tapered seat seal.
cutoff port travel
As delivered, the Tilton 77 Series master cylinder has been blueprinted for
a cutoff port travel distance within the range of .030" to .050". This can by
altered by changing the thickness of the sealing ring located between the
master cylinder body and the end cap (visible from outside). Increasing
the thickness of this seal increases the cutoff port travel an equal amount.
Reducing the thickness reduces it by an equal amount. Seal kits of varying
thicknesses are available from Tilton. It is recommended not to reuse the
shims since work hardening of the shim material can prevent proper seal-
ing in the future.
4.20
7.95
6.68
3 POSITION ADJUSTABLE
PEDAL RATIO VERTICAL
POSITION ON BRAKE PEDAL:
HIGH 6.25 to 1
MIDDLE 5.37 to 1
LOW 4.70 to 1
4.5 ±.5
R 11.84
4.33
9.37
.425
3.68
1.870
-3 AN FEMALE
OUTLET PORT
-4AN MALE
INLET FITTING
TILTON P/N 77-015
INLET FITTINGS ARE NOT INCLUDED WITH MASTER CYLINDERS.
SUITABLE FITTINGS FOR YOUR PARTICULAR INSTALLATION
MUST BE PURCHASED SEPERATELY.
TILTON ENGINEERING
77 SERIES MASTER CYLINDER
5/8" TO 1" BORE
2.60 2.6
2.60
2 PL
2.8
7.25
2 PL