SnowEx SS-4000 - Manual (Page 20)

20 © TrynEx International 2013 (REV A) F51067A
Maintenance Instructions
Maintenance Plan / Cleaning
before every
use
after the following operating hours
after 3 month
min.
at least
anually
after every
cleaning
5 10 25 50 100
Check screws and nuts C
Check motor oil level, refill if necessary C
First motor oil change S
All further motor oil changes S S
Check air filter C
Clean air filter element, earlier if necessary M M
Replace air filter element, earlier if necessary M
Replace fuel hoses S (2 Years)
Clean cool air screen
M
Clean baffle plate, cooling ribs, earlier if neces-
sary
S
Clean spark plugs, adjust gap S
Replace spark plugs S
Clean exhaust M
Lubricate all moving parts M M
Check hand lever play setting C
Check brush wear, earlier if necessary C
Stretch chain drive C S
KEY
S Maintenance by Specialist
C Check by Operator
M Maintenance by Operator
IMPORTANT
If you are not intending to use the machine for a long time, it should be properly stored. Please contact your local dealer for
suitable storage practices in your geographic location.
CLEANING
To keep your SS-4000 in good condition, you should clean it regularly.
Remove loose dirt or dust with a car wash brush. Wash plastic surfaces with water and soap. Use normal car cleaning soap. Rinse off all
cleaners thoroughly with clean water.
To give plastic parts a gloss finish, use a plastics care product.
Observe the instructions on the cleaning solution package.
You can use glycerine as a corrosion protection for heavily soiled parts.
Do not use pressure washers, the high pressure may force water into bearings, seals and the motor, causing damage.