SnowEx SS-4000 - Manual (Page 18)

18 © TrynEx International 2013 (REV A) F51067A
Turn the throttle cable the
direction you desire using
an 8 mm wrench.
Loosen the top nut with a
10 mm wrench.
Tighten the nut. Check
the adjustment by press-
ing the lever down.
Reverse Lever: there
should be about 3-1/8
inches (80 mm) of space
between the handlebar
and lever when there
starts to be a resistance
to the lever.
Brush Drive and Forward
Levers: there should be
about 5-1/2 inches (140
mm) of space between
the handlebar and lever
when there starts to be a
resistance to the lever.
Maintenance Instructions
Adjusting Control Cables
IMPORTANT
It may be necessary to reset the cables after machine has been operating for a few hours.