SnowEx SP-9300 - Manual (Page 26)

© Trynex International 2009 L1218 MAX— 26
Operating the Spreader
PREPARATION
CAUTION – Sweep area clear of foreign objects or obstacles that could cause personal injury. Keep other persons, children,
or animals our of the area to be spread.
SPREADER LOADING
WARNING – Do not overload vehicle. Use chart below to calculate weight of material. Weights of material are an average for
dry materials.
Material Weight Per Cubic Ft.
Rock Salt 35-40 lbs.
Sand/Salt Mix 95-120 lbs.
t Be sure to comply with manufacturer’s maximum gross vehicle weight ratings.
t Warning – Never leave material in hopper for long periods of time as salt is hygroscopic and will attract atmospheric
moisture and harden up. When spreading sand mix, a 1:1 ratio for Sand/Salt mix is recommended to prevent the
material from freezing.
SPREADING TIPS
t Never exceed 10 m.p.h. when spreading.
t For a wider pass, increase spinner speed.
t For a heavier pass, drive slower, or increase auger speed.
t Never operate spreader near pedestrians.
t Spread ice melters with the storm to prevent unmanageable levels of ice.
t Calculate spread pattern when near vegetation.
V-Maxx 9300 CONTROL OPERATION
t The Dual Variable Speed Control has dual finger-tip dials for maximum performance, digital system status with warning
protection and built-in vibrator switch.
t To start, press power switch on controller and spreader will accelerate to speed set on spinner and auger dials.
t To stop, press power switch on controller to off position.
t Speed of auger and spinner may be adjusted separately to get desired flow and spread distance from spreader.
t The Vibrator Switch is needed for dense material or to increase the flow to the auger. This eliminates bridging of material
in hopper.
t In case spreader becomes jammed, it will go into an auto-reverse program to free itself. Auger display will show (AR)
while trying to clear obstruction.
Model # SP-9300