Seed Hawk LOUP III & VIPER PRO 2013 - Hydraulic Drive Calibration Guide User Manual
Page 19
Seed Hawk
®
Manual Calibration Guide
18
Once the weight is entered, toggle to the far RIGHT until
“SEND” appears. Select “SEND” to save the calibration number
to the Viper Pro™. Repeat the steps for the remaining meters.
To turn OFF the remote calibration console, press and hold
the blue power button until the monitor powers down.
NOTE: DO NOT include the weight of the calibration bucket in
the metered weight value.
Information is instantly sent to the Product Node.
After all meters are calibrated the Remote tank calibration
console MUST be properly powered down and disconnected
from tank harness.
DO NOT leave the Remote tank calibration console attached to
the tank exposed to the weather.
NOTE: It is recommended to repeat the calibration to avoid
operator error.