5 calibration procedure - viper pro – Seed Hawk LOUP III & VIPER PRO 2013 - Hydraulic Drive Calibration Guide User Manual

Page 15

Text mode
Original mode

Seed Hawk

Manual Calibration Guide

3.5 Calibration Procedure - Viper Pro™

ATTENTION: Before a meter calibration can be done the
implement width must be entered and the speed calibration
must be completed (See Section Setup Wizard and
Calculating the speed Calibration sections of your Seed
Hawk Viper Pro™ Manual).

ATTENTION: Exit to the Seed Hawk Viper Pro™ Main Menu
on the Viper monitor before powering up the Remote
Calibration Console.

NOTE: For convenient
calibration, use the remote
calibration console that
attaches to the tank
harness.