3 calibration procedure - loup iii – Seed Hawk LOUP III & VIPER PRO 2013 - Hydraulic Drive Calibration Guide User Manual

Page 11

Text mode
Original mode

Seed Hawk

Manual Calibration Guide

3.3 Calibration Procedure - Loup III

Step 1:

Select "Meter

Calibration" from the
Menu Settings.

Step 2: Select the desired
meter to calibrate.

Step 3: Set to the desired
shaft speed and select
"Prime"

NOTE: It is important to calibrate as close to the actual seeding
RPM of the roller. Reference the “Roller RPM Chart” to get an
approximate roller RPM for the specific roller and drill width.