RIKON Power Tools 25-010 - Manual (Page 7)

7
Assembly
4.1 Installing the in-feed table:
1. Remove the four socket head cap
screws from table cover rails, already
fitted Fig.4.1.
2. Take the in-feed depth of cut adjust-
ing bar. Remove the collar and spring
washer Fig.4.2.
3. Thread bar through underside of ta-
ble then re-fit and secure collar Fig.4.3.
4. Hold table up to machine while
threading depth of cut control bar into
spacer shaft Fig.4.4.
5. Fit the infeed table into position
under the table cover rails and wind
the depth of cut bar until the uppermost
line on the depth scale is registered.
Re-fit and secure the table cover rails,
Fig.4.5. These rails should not be fully
tightened as the table needs to slide up
and down in order to adjust the depth of
cut. As a guide fully tighten the socket
head cap screws and back them off a
1/4 turn.
4.2 Installing the thicknessing dust
extraction outlet:
Stand to the opposite side of the ma-
chine, locate the slotted extrusion and
hold the extraction outlet into position
Fig.4.6. Secure this outlet into the slot
using 4 self tap screws and washers
Fig.4.7.
4.3 Installing the outfeed table:
1. Hold the outfeed table over the lugs
on planer body and lock the table in
place with the levers Fig.4.8.
4.4 Table adjustment:
1. Ensuring that the infeed table is set
to the upper line on the scale run a
straight edge across both tables. They
should be set at the same height and
perfectly level, if not adjust the outfeed
table using the adjustment plates on
either side of the table.
2. To adjust the angle of the table use
the jacking screws Fig.4.9.
3. To adjust the height of the table undo
the Allen bolts and slide the mounting
plate accordingly Fig.4.10. To make this
adjustment it is advisable to remove the
table and set the gap into the elongated
hole with dividers or callipers.
Fig.4.1
Fig.4.2
Socket head
cap screw
Table cover
rails
Collar
Fig.4.4
Collar
Fig.4.5
Spacing bar
Fig.4.5
Socket head cap screw
Table
cover rail
Depth of
cut bar
Depth scale
Fig.4.6
Fig.4.7
Fig.4.8
Slotted
extrusion
Slot
Self tap screw
& washer
Location
Lugs
Locking
levers
Fig.4.9
Jacking
screw
Fig.4.10
Allen bolts
Gap