Operation – RIKON Power Tools 25-010 User Manual

Page 13

Operation

To increase the depth of cut simply rotate the infeed

adjustment knob anticlockwise Fig.5.5C.

6.4 Jointing:

For jointing the narrow sides of a workpiece release the

blade guard lock lever and set blade guard to width of

workpiece. The plastic spring on the end of the blade

guard should exert a slight pressure against the work-

piece. Lock blade guard in place and start the machine.

Push workpiece slowly and steady against cutter block.

Ensure that fence is set at true 90° (or any other angle

required – see Assembly – Adjusting Fence) and work-

piece is kept flush against fence Fig.5.6.

After straightening side 1, turn the workpiece 90º so

that side 1 now lines up along the fence. Surface side

2 at 90° in order to carry out thicknessing: this way it is

possible to obtain a finished piece planed on all 4 sides

Fig.5.7A.

Fig.5.6

Fig.5.5C

Adjustment Knob

Fig.5.7A

Fence

90º

Infeed Table