Rhino Shelter SHED-5WX10LX8H - Manual (Page 8)

Assembly Instructions
5x10x8 CycleCabana
TM
V1.0
Do NOT Return Assembly To Dealer or Store. For All Questions or Shortages Please Call MDM Products Directly
Customer Service 800-447-7079 or 203-877-7070
7
secured in position so it does not move as end doors
and m
tened over frame. This step is
key vent door movement in wind.
ain cover are tigh
to good fit and to pre
he rope channels should be located inside the unit, with
n
nd panel into position.
T
the frame members passing through the pre-cut slits i
the end panel/door. Replace and tighten the carriage
bolts after putting the e
When putting on the doors, adjust the length to make
certain the doors do not drape onto the ground. A
by pulling more or less material over end arch. If pulling
djust
em up puts too much stress on the slit where it goes
her
ve
the
e
door fit. Tie off
e end off the rope to a second turnbuckle attached to a
th
over the wind brace, use a sharp knife to cut slit anot
inch or two to relieve it. The PE fabric is rip-stop wea
and will only separate where cut.
Tie off one end of the rope coming out of the end panel
to a turnbuckle. Turnbuckle should be loosened all
way and the open hook end attached to the hole in the
inside of the end arch. Hold the end of the unsecured
rope and apply pressure downward with a foot to remov
excess. Re-adjust gathered material evenly along door
rope. This step is key to getting a good
th
hole in the foot of the end arch on the opposite side.
The end panel can be adjusted further by tightening the
turnbuckles.
Note: Adjust/Snug the end panel by turning the
turnbuckles or repeating step 3 on a regular basis
Step 10 - Main Cover Installation
To elongate the life of Main Cover, put a small square of
duct tape (field supplied) over each bolt head on frame
omes in contact with cover. The tape acts as a cu
that
shion to
void rubbing damage to the cover over years.
Unpack the Main Cover (Part #23) from the protective
plastic packaging. The line of grommets on the inside
(white) of the cover on the tie down Flap run parallel to the
sides of the frame assembly for positioning. Once cover is
oriented properly to the Frame Assembly, pull Main Cover
over frame assembly from the side, being careful not to
snag the cover on any member, bolt, or other obstruction.
Center the Main Cover over the Frame Assembly with the
Main Cover colored side showing from the outside of the
unit.
c
a