Rhino Shelter SHED-5WX10LX8H - Manual (Page 10)

Assembly Instructions
5x10x8 CycleCabana
TM
V1.0
Do NOT Return Assembly To Dealer or Store. For All Questions or Shortages Please Call MDM Products Directly
Customer Service 800-447-7079 or 203-877-7070
9
Maintenance and Care
, the unit should be completely
r
nnually or more often A
inspected internally and externally to make certain the
unit remains properly installed and secured. Particula
attention should be paid to:
Hardware – check all carriage bolts and hardware
connectors to be certain they are in place and tightened
Anchors
.
– during normal weather trends, the unit will
train against the anchors under windy conditions. s
Anchor hardware connection to frame members should
be maintained tight and depth of anchors should be
checked to be certain they remain deeply and firmly set.
Snow Accumulation – all snow accumulation on the main
cover should be removed as soon as practical. The
days following the snowfall when the snow melts are
when most snow damage can occur. Unit is not
designed for any amount of accumulated snow or ice.
Tap the main cover from the inside with a broom end to
knock off any accumulated snow.
Main Cover Lacing – the poly rope that secures the main
cover to the bottom rail of the frame assembly should be
checked, and adjusted as needed. The tension on the
main cover should be uniform from end to end and side
to side. Rope ends must e tied off onto the frame
b
ach s me b
m ers at the ends on e ide.
Tur ckle Adjustment nbu – during normal wind conditions
nd load, the doors and main cover adjustment points at
e turnbuckle should be checked and tightened as
ecessary. The turnbuckles should be neither
ompletely extended nor taken up, so that turnbuckle
hould be tight when in the mid range of overall
djustment. If necessary, readjust rope tie off on
rnbuckle as needed to tighten or loosen as needed.
a
th
n
c
s
a
tu
leaning C – cover and doors can be cleaned with a
h
r
g dirt and
mage
mixture of light detergent and water. A soft bristle brus
with the mixture can be used to loosen any hard dirt,
mold, or buildup on the cover. After cleansing, the cove
should be rinsed thoroughly to avoid any chemical
action from residual detergent. Allowin re
debris to sit on cover over an extended time will da
cover irreparably.
Severe Weather – in preparation for inclement weathe
completely secure the doors on both ends of your MD
Products shelter/garage. Allowing wind to enter either
end lifts the building and puts undue stress on the
anchoring system. This also shortens the life of the
doors, zippers, and main cover.
r,
M
Customer Service or Installation Assistance
.
se documentation for your MDM
n
Please call MDM Products at 800-447-7079 or 203-877-
7070 for questions about the installation of the unit in any
way. Care and attention to a proper installation will add
many years of life and function to your MDM Products unit
Please retain purcha
Products unit. All warranty claims must include purchase
documentation for verification. All parts on your MDM
Products unit are available for replacement as needed.
Protect your purchase by completing warranty registratio
card and mail/fax as soon as practical after installing your
unit.