Rhino Shelter SHED-5WX10LX8H - Manual (Page 7)

Assembly Instructions
5x10x8 CycleCabana
TM
V1.0
Do NOT Return Assembly To Dealer or Store. For All Questions or Shortages Please Call MDM Products Directly
Customer Service 800-447-7079 or 203-877-7070
6
Pre-Drill Holes if there are any rocks in ground
Drive Rod inserts into Anchor Head
Place
lanyard
ground.
ANCHOR STEP 2
the Drive Rod through the loop in the anchor
. Pull upward to set anchor head into the
end of
upright
cross
k can be
ht.
ANCHOR STEP 3
Slip one side of the U-bolt through the eyelet at the
the anchor cable. Attach the cable to the Arch leg
with the U-bolt and tighten. Do not attach to base
rails. Ensure there is no slack in the cable. Slac
removed by wrapping the cable around the arch uprig
Step 9 - Door Panel Installation
Note: Both End Panels MUST be installed before
installing Main Cover onto frame.
art #24) on ends of the Frame assembly.
Place the end panel over the first arch and wrap the
material around the arch bringing the slits in the end panel
to the inside of the frame arch. End Door Panels have pre-
cut slits that allow frame members to pass through so rope
pocket is inside unit. Place the top ridge cross rail pole and
the side cross rails through the material slits and replace
the carriage bolts and tighten. The door end will also
require removal of the wind brace bolts and placement of
the wind braces through slits in the ends panel. Reconnect
wind braces with carriage bolts once end panel is put into
place.
Door assembly is drawn over frame by tightening rope and
securing to turnbuckles at the arch foot. Frame must be
Note that one door has a Full Width opening and the other
a Manway opening. Plan location of each before installing
door ends.
Remove Carriage bolts from the Top Crest Rail and the two
pper Cross Rails. Install End Panel Doors w/Zippers U
(P
Pull U-Bolt &
Anchor Loop up
on Arch Base and
Tighten
Anchor Loop
Drive
Rod