Rhino Shelter SHED-5WX10LX8H - Manual (Page 6)

Assembly Instructions
5x10x8 CycleCabana
TM
V1.0
Do NOT Return Assembly To Dealer or Store. For All Questions or Shortages Please Call MDM Products Directly
Customer Service 800-447-7079 or 203-877-7070
5
Figure 4 Finished Frame
Anchoring Frame To Ground
orted, tighten nce frame is square and properly supp O
carriage bolts on all frame members, except for End
Arch members to Cross Rails along base, side, and top.
Do not over tighten or oval tubing. After hardware is
tightened, insert plastic end plugs (#16) (1 5/8”) & (#15)
(1”) into all open ends of frame members.
NOTE: Frame must be anchored before
ding comes with 12
d to
as
installing any doors or cover.
ach MDM Products 5x10x8 buil E
EARTH CABLE ANCHORS with U-bolts and nuts.
These versatile anchors allow the frame to be secure
almost any surface. In addition a 36” Drive Rod is
provided to drive the anchor heads into the earth.
the location where you are placing the building h If
very hard ground or any rock in it, pre-drill the holes
before inserting anchors. Hammer drills can be rente
at most home improvement or rent-all centers. Hitting
the anchors into rock will cause the drive rod end to
mushroom inside the anchor head, and prevent the drive
rod from coming out of the hole.
d
Anchor placement should be made inside the frame at the
NCHOR STEP 1
rovided into the cup of the
into the
interior corners of the unit, and midway along the sides of
the frames. Anchors secure the building to the ground, as
well as prevent spread of the frame over time.
A
lace the drive rod p P
anchor. Using a heavy hammer drive the anchor
soil until 6-8 inches of cable remains above the earth.
Remove drive rod.