Rhino Shelter BARN-12W X 28L X 12H - Manual (Page 9)

Assembly Instructions Barn Style 12 x 28 x 12
V1.2
Do NOT Return Assembly To Dealer or Store. For All Assembly Questions or Shortages Please Call MDM Products Directly
Customer Service 800-447-7079 or 203-877-7070
9
Door Turnbuckle Attached to Base Foot
When putting on the doors, adjust the length to make
certain the doors do not drape onto the ground. Adjust
door length by pulling more or less fabric over end arch.
If pulling them up puts too much stress on the slit where
it goes over the wind brace, use a sharp knife to cut slit
another inch or two to relieve it. The PE fabric is rip-stop
weave, and can easily be cut to relieve stress at the
frame members.
Door Edge Should Not Touch
Ground
Step 3. Tie off one end of the rope coming out of the
end panel to a turnbuckle. Turnbuckle should be
loosened all the way and the open hook end attached to
the hole in the inside of the end arch. Hold the end of
the unsecured rope and apply pressure downward with a
foot to remove excess. Re-adjust gathered material
evenly along door rope. This step is key to getting a
good door fit. Tie off the end off the rope to a second
turnbuckle attached to a hole in the foot of the end arch
on the opposite side. The end panel can be adjusted
further by tightening the turnbuckles.
Side Cross
Rail
Wind Brace
Note: After door panel is installed with all slack out
of rope, adjust/snug the end panel by turning the
turnbuckles or repeating step 3 on a regular basis
MAIN COVER INSTALLATION
Step 1. To elongate the life of Main Cover, put a small
square of duct tape (field supplied) over each bolt head
on frame that comes in contact with cover. The tape