Rhino Shelter BARN-12W X 20L X 12H - Manual (Page 9)

Assembly Instructions Barn Style 12 x 20 x 12
V1.2
Do NOT Return Assembly To Dealer or Store. For All Assembly Questions or Shortages Please Call MDM Products Directly
Customer Service 800-447-7079 or 203-877-7070
9
Step 3. Tie off one end of the rope coming out of the
end panel to a turnbuckle. Turnbuckle should be
loosened all the way and the open h
e hole in the inside of the end arch. Hold the e
ook end attached to
nd of
cond
th
the unsecured rope and apply pressure downward with a
foot to remove excess. Re-adjust gathered material
evenly along door rope. This step is key to getting a
good door fit. Tie off the end off the rope to a se
turnbuckle attached to a hole in the foot of the end arch
on the opposite side. The end panel can be adjusted
further by tightening the turnbuckles.
l slack out Note: After door panel is installed with al
of rope, adjust/snug the end panel by turning the
turnbuckles or repeating step 3 on a regular basis
MAIN COVER INSTALLATION
Step 1. To elongate the life of Main Cover, put a small
quare of duct tape (field supplied) over each bolt head
on frame that comes in contact with cover. The tape
r
s
acts as a cushion to avoid rubbing damage to the cove
over years.
Unpack the Main Cover #17 from the protective plastic
packaging. The line of grommets on the inside (white) of
the cover on the tie down Flap runs parallel to the sides
of the frame assembly for positioning. Once cover is
oriented properly to the Frame Assembly, pull Main
Cover over frame assembly from the side, being careful
not to snag the cover on any member, bolt, or other
obstruction. Center the Main Cover over the Frame
Assembly with the Main Cover colored side showing
from the outside of the unit.
Step 2. Secure the Main Cover Corners - Loosen the 4
remaining turnbuckles completely. Place the
turnbuckles into outer hole in the foot of each end arch.
Tie off the rope coming out of the Main Cover rope slot
on either side to the turnbuckles. After securing one end
of the rope in the Main Cover, pull the excess slack out
of the rope and cover to tighten. Hold the end of the
unsecured rope and apply pressure downward with a
foot to remove excess. Temporarily tie the end of the
rope to the turnbuckle.
Door Edge Should Not Touch
Ground