Rhino Shelter BARN-12W X 20L X 12H - Manual (Page 3)

Assembly Instructions Barn Style 12 x 20 x 12
Barn Frame
SITE PREPARATION
Assembly 12 x 20 x 12
V1.2
Do NOT Return Assembly To Dealer or Store. For All Assembly Questions or Shortages Please Call MDM Products Directly
Customer Service 800-447-7079 or 203-877-7070
3
Select a level or as close to level as practical locatio
your Rhino Shelter unit. The unit should be placed on a
base of materials suitable for the storage load to be
protected. A bed of crushed process rock will make an
ideal base. The unit should not be located under trees,
which will shed hard fruit such as apples, walnuts, or
heavy pine cones. The cover of your unit will protect
against normally leaves and light debris, however large
branches or other falling items may cause puncture or
tears in the cover material.
Take notice of drainage both near and around your
ntended location. Wat
n for
er draining from the surrounding
Check to be certain that adequate clearance is allowed
for entry and exit from ends of unit. As unit has doors on
both ends, ideally vehicle or contents can be inserted or
removed from either end.
FRAME ARCH ASSEMBLY
Step1. Assemble the (2) Front and Rear End Arches
using (1) #3 Ridge Bend MxM, (2) #4 Ridge Bend MxF,
(2) #5 Ridge Bend FxF, and (2) #2 End Upright with Foot
for each arch. Use (4) 4” carriage bolts with nuts and
upped washers through pre-drilled holes in frame
i
terrain should be planned so that it does not run into the
unit. As well, rain or melting snow that comes off the
unit should be drained away rather than accumulate and
pool around the unit.
c
members.
Be certain to insert carriage bolts from the outer edge
into the interior of the unit, with the washers and nuts on
the inside of the arches. This will avoid tearing the fabric
on doors and main cover when installed. Do not tighten
Interior Arch