Rhino Shelter BARN-12W X 20L X 12H - Manual (Page 4)

Assembly Instructions Barn Style 12 x 20 x 12
V1.2
Do NOT Return Assembly To Dealer or Store. For All Assembly Questions or Shortages Please Call MDM Products Directly
Customer Service 800-447-7079 or 203-877-7070
4
the nuts completely until the frame is completed and set
in place.
Step 2. Assemble the (2) Corner Wind Braces #8 to #2
End Upright w/Foot to the first of the End Arch
assemblies. Use a #11 3”Bolt with Washer and Nut to
ecure the braces loosely to the Upright. Do not tighten
F,
ge Bend FxF, (2) #4 Straight Upright, and (2)
s
completely.
Step 3. Assemble the remaining four interior arches
using (1) #3 Ridge Bend MxM, (2) #4 Ridge Bend Mx
) #5 Rid (2
#9 Steel Foot with Plate for each of the arches. Use 4”
carriage bolts with washers and nuts in the pre-drilled
holes, aligned to form the arch.
COMBINE END ARCH & INTERIOR ARCH
Support the End Arch with Wind Braces temporarily in
the vertical position. Connect (4) #7 Plain End FxF
Cross Rails to the first End Arch with (4) 3” Carriage
olts, washers, and nuts through the pre-drilled holes in
e arch members. The Swedged end of the Cross Rails
hould face the interior of the unit to accept the next
cross rail. The Cross Rails should be put into the bottom
in, don’t tighten
oss rails are
r
and side hole of the arch upright. Aga
he hardware until the next arch and cr
b
th
s
t
assembled. It is very important to make certain all nuts
are on the inside of the unit to avoid damaging the cove
when put on.
ections. Using (4)
arch as shown in the frame illustration. Once the
Stand the first End Arch Assembly and the first Interior
Arch Assembly up vertically into position. The base and
side cross rail end holes align with the holes in the
interior arch to make the first conn
with nuts and washers, connect the cross rails between
the end arch and the first interior arch assemblies. The
two Arches must be supported upright until the Wind
Braces are put into place or the frame will fall. Connect
the (2) #8 Wind Braces diagonally across the end and
interior
Wind Brace are installed the frame will be self-
supporting.
ross
Rail FxF underneath
Begin the Top Ridge Cross Rail by placing a #7 C
the End Arch Top Crest Tube.
#2 Upright
with Foot
#5 Ridge
Bend
FxF
#4 Ridge
Bend MxF
#3 Ridge
Bend MxM
#9 Steel Foot
#1 Straight Upright
#5
B
F Ridge
end
xF
#4 Ridge
Bend MxF
#3 Ridge
M Bend Mx
Interior Arch
Assembly
End Arch
Assembly
Wind Brace
End Arch
Assembly
with first
Cross Rails