Rhino Shelter BARN-12W X 20L X 12H - Manual (Page 5)

Assembly Instructions Barn Style 12 x 20 x 12
V1.2
Do NOT Return Assembly To Dealer or Store. For All Assembly Questions or Shortages Please Call MDM Products Directly
Customer Service 800-447-7079 or 203-877-7070
5
il.
s
Secure the Cross Rail loosely with a 3” Carriage Bolt
with washer and nut facing the interior of the unit. Male
End of next Cross Rail fits into Female end of cross ra
Cross Rails are built by placing rails into each other on
the same carriage bolt.
Add #6 Cross Rails MxF to base, side and top ridge
before adding the next Interior Arch. The carriage bolt
on the arch assemblies also go through the common
hole on each rail assembly.
Side & Top Cross Rails between Arch Assemblies
tep 5 – Add Remaining Arches To Frame S
ame fashion. Note that the Swedged Cross Rails #6
Add remaining 3 interior arches and rear end arch in the
s
should fasten under the Top Ridge Bend of the final End
Arch and above the Top Ridge Bend of the interior
arches.
NOTE: Do not completely tighten bolts that connect the
Cross Rails to the End Arches. They must be removed
for proper End Panel Zippered Door installation
Add Cross Rails in preparation for adding Arch
Assemblies
SQUARE & LEVEL FRAME
Adjust the frame assembly in its final installation
location. This should be done with more than one
person lifting each side or corner to avoid bending or
stressing any frame members. Frame must now be
squared up in position.
Align one end corner in the final position desired. Use a
line strung from front to back to align all arch members
on that side from end to end. Each corner of the Barn
style has a hole vertically through the foot base. Put the
end arch exactly where desired, and insert #12 Round
3/8” Metal Peg into ground to prevent leg base from
moving. Install the Leg Peg into the other end corner
foot base. Re-check the position of all interior arch
uprights for alignment.