Installing the dryer – Alliance Laundry Systems DRY710C User Manual

Page 9

Installation

513005

Installing the Dryer

Step 1: Position and Level the Dryer

Install dryer before washer. This allows room for

attaching exhaust duct.
Install the four rubber feet (in accessories bag).
Select a location with a solid floor. Dryers installed in

residential garages must be elevated 18 inches (46 cm)

above the floor.
No other fuel burning appliance should be installed in

the same closet with the dryer.
The dryer must not be installed or stored in an area

where it will be exposed to water and/or weather.
The dryer needs sufficient clearance and an adequate

air supply for proper operation and ventilation, and for

easier installation and servicing. (Minimum clearances

are shown in Figure 4).
Place the dryer in position, and adjust the legs until the

dryer is level from side to side and front to back.

Leveling legs can be adjusted from inside the dryer

with a 1/4 in. driver. All four legs must rest firmly on

the floor so the weight of the dryer is evenly

distributed. The dryer must not rock.

Figure 3

IMPORTANT: In mobile home installations, gas

dryers MUST be permanently attached to the floor

at the time of installation. Order No. 526P3 Hold

Down Kit (available at extra cost) for a

manufactured (mobile) home installation. Follow

the instructions supplied with the kit.

Installation of unit must conform to the Manufactured

Home Construction and Safety Standards, Title 24

CF4, Part 32-80 or Standard CAN/CSA-Z240 MH.

DRY2355N

Dryer Base

Level

Leveling Leg

Rubber Foot