Warning – Alliance Laundry Systems DRY710C User Manual

Page 24

Installation

513005

8. Using screwdriver, remove two door plugs, and

reinstall on opposite side of door opening.

9. Reinstall four hinge attaching screws, removed in

Step 1.

Step 6: Wipe Out Inside of Dryer

Before using dryer for the first time, use an all-purpose

cleaner, or a detergent and water solution, and a damp

cloth to remove shipping dust from inside dryer drum.

Step 7: Plug In the Dryer
Electric Dryer

Connect the dryer to an electrical power source. Refer

to Step 4 for information on connecting power cord.

Figure 31

Gas Dryer

Dryer requires 120 Volt, 60 Hertz electrical supply and

comes equipped with a 3-prong grounding plug. Refer

to serial plate for specific electrical requirements.

NOTE: The wiring diagram is located inside the

control hood.

When plugging in the dryer:

 Do not overload circuits.
 Do not use an adapter.
 Do not use an extension cord.
 Do not operate both a washer and gas dryer on

the same circuit. Use separately fused 15 amp

circuits.

Figure 28

Figure 29

D604I

Figure 30

D317S

D606I

D604I

D275I

Connect to 30 Amp circuit.

To reduce the risk of fire, electric shock,

serious injury or death, all wiring and

grounding MUST conform with the latest

edition of the National Electrical Code,

ANSI/NFPA 70, or the Canadian Electrical

Code, CSA C22.1, and such local

regulations as might apply. It is the

customer’s responsibility to have the wiring

and fuses installed by a qualified electrician

to make sure adequate electrical power is

available to the dryer.

W521

WARNING