Maintenance, Warning, Lubrication – Alliance Laundry Systems DRY710C User Manual

Page 31: Care of your dryer

513005

Maintenance

Lubrication

All moving parts are sealed in a permanent supply of

lubricant or are equipped with oilless bearings.

Additional lubrication will not be necessary.

Care of Your Dryer

Dryer Interior

Wipe the surfaces using a soft cloth and household

cleaner or a non-abrasive paste of powdered laundry

detergent and hot water, followed by a short heat cycle

with a load of rags.
To remove crayon or ball point ink off the dryer drum,

put the heat on high and use old rags in the dryer to

absorb the crayon or ink. If unsuccessful, contact the

appliance dealer. DO NOT use any chemicals in the

dryer.

IMPORTANT: The use of chlorine bleach for

removing any discolorations should be avoided

because bleach could damage the finish.

Cabinet

Wipe the dryer cabinet as needed. If detergent, bleach

or other washing products have been spilled on the

dryer, wipe immediately. Some products will cause

permanent damage if spilled on the cabinet.

Control Panel

Use only a damp or sudsy cloth for cleaning the

control panel. Some spray pretreat products may harm

the finish on the control panel.

NOTE: The wiring diagram is located inside the

control panel.

Exhaust System

The exhaust duct should be inspected after one year of

use and cleaned if necessary by a qualified service

person to remove any lint build-up. Inspect and clean

exhaust duct every one to two years as required

thereafter.
The weather hood should be checked frequently to

make sure the dampers move freely, dampers are not

pushed in and that nothing has been set against them.
Keep dryer area clear and free from combustible

materials, gasoline and other flammable vapors and

liquids.
Do not obstruct the flow of combustion and ventilation

air.

NOTE: Verify proper operation after servicing.

To reduce the risk of an electric shock,

serious injury or death, disconnect the

electrical service to the dryer before

cleaning the interior.

W132

WARNING

Label all wires prior to disconnection

when servicing controls. Wiring errors

can cause improper and dangerous

operation.

W049

WARNING

To reduce the risk of electric shock,

disconnect the electrical service to the

dryer before cleaning.

W043

WARNING