Lincoln Electric IM874 VANTAGE 300 - Manual (Page 11)

LIFTING
The VANTAGE 300 (Kubota) weighs approximately
1150 lbs. (522kg.) with a full tank of fuel (1035 lbs.
(470kg.) less fuel). The VANTAGE 300 (Deutz) weight
approximately 1265 lbs. (574 kg.) with a full tank of
fuel (1150 lbs. (522kg.) less full). A lift bail is mounted
to the machine and should always be used when lift-
ing the machine.
HIGH ALTITUDE OPERATION
At higher altitudes, output derating may be necessary. For
maximum rating, derate the machine 2.5% to 3.5% for every
1000 ft. (305m). Due to new EPA and other local emissions
regulations, modifications to the engine for high altitude are
restricted within the United States. For use above 6000
ft.(1828 m) an authorized engine field service shop should
be contacted to determine if any adjustments can be made
for operation in higher elevations.
HIGH TEMPERATURE OPERATION
At temperatures above 104°F (40°C), Welder output
derating is necessary. For maximum output ratings,
derate the welder output 2 volts for every 18°F (10°C)
above 104°F (40°C).
COLD WEATHER STARTING:
With a fully charged battery and the proper oil, the
engine should start satisfactorily down to 5°F (-15°C).
If the engine must be frequently started at or below
23°F (-5°C), it may be desirable to install cold-starting
aides. The use of No. 1D diesel fuel is recommended
in place of No. 2D at temperatures below 23°F (-5°C).
Allow the engine to warm up before applying a load or
switching to high idle.
Note: Extreme cold weather starting may require
longer glow plug operation.
Under no conditions should ether or other starting
fluids be used with this engine!
------------------------------------------------------------------------
WARNING
A-3 INSTALLATION
VANTAGE 300
A-3
SAFETY PRECAUTIONS
Only qualified personnel should install,
use, or service this equipment.
LOCATION AND VENTILATION
The welder should be located to provide an unrestrict-
ed flow of clean, cool air to the cooling air inlets and to
avoid restricting the cooling air outlets. Also, locate the
welder so that the engine exhaust fumes are properly
vented to an outside area.
STACKING
VANTAGE 300 machines cannot be stacked.
ANGLE OF OPERATION
Engines are designed to run in the level condition
which is where the optimum performance is achieved.
The maximum angle of continuous operation is 20
degrees in all directions, 30 degrees (Kubota) and 30
degrees (Deutz) Intermittent (less than 10 minutes
continuous) in all directions. If the engine is to be
operated at an angle, provisions must be made for
checking and maintaining the oil level at the normal
(FULL) oil capacity in the crankcase.
When operating the welder at an angle, the effective
fuel capacity will be slightly less than the amount
specified .
Do not attempt to use this equipment until you
have thoroughly read the engine manufacturerʼs
manual supplied with your welder. It includes
important safety precautions, detailed engine
starting, operating and maintenance instructions,
and parts lists.
------------------------------------------------------------------------
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts or
electrode with skin or wet clothing.
• Insulate yourself from work and
ground
• Always wear dry insulating gloves.
------------------------------------------------------------------------
ENGINE EXHAUST can kill.
• Use in open, well ventilated areas or
vent exhaust outside.
------------------------------------------------------------------------
MOVING PARTS can injure.
• Do not operate with doors open or
guards off.
• Stop engine before servicing.
• Keep away from moving parts.
------------------------------------------------------------------------
See additional warning information at
front of this operatorʼs manual.
WARNING
• Lift only with equipment of adequate
lifting capacity.
• Be sure machine is stable when lift-
ing.
• Do not lift this machine using lift bail
if it is equipped with a heavy acces-
sory such as trailer or gas cylinder.
FALLING • Do not lift machine if lift bail is
EQUIPMENT can damaged.
cause injury. • Do not operate machine while
suspended from lift bail.
--------------------------------------------------------------------------------
WARNING