Lincoln Electric IM980 RED-D-ARC EX350ie (CE) - Manual (Page 23)

E-4 TROUBLESHOOTING E-4
Observe all Safety Guidelines detailed throughout this manual
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your
Local Authorized Field Service Facility for technical troubleshooting assistance before you proceed.
CAUTION
EX350ie (CE) (RED-D-ARC)
Fault Codes
Code Description Corrective Action
31 Primary over current. If condition persists The machine needs to
contact an authorized be turned off and back
Field Service Shop on to reset the machine.
32 CAP bank A under voltage. Check input power Self-clearing as
33 CAP bank B under voltage. reconnect to make sure condition ceases.
34 CAP bank A over voltage. the machine is connected
35 CAP bank B over voltage. for the input power being
37 Soft start Failed. supplied. Cycle power.
39 Glitch on the primary over Check the machine Self-clearing as
current fault interrupt; possibly ground. condition ceases.
caused by noise or a signal level If problem persists
(misc. hardware fault #1) contact an authorized
Field Service Shop
43 CAP delta; CAP A and B are out Check input power
of balance. reconnect to make sure
the machine is
connected for the input
power being supplied.
44 Main CPU problem. The DSP Check the machine
has detected a problem with the ground.
CPU.
47 Glitch on the CAP/heart beat If problem persists
interrupt; possibly caused by contact an authorized
noise or a signal level right at Field Service Shop
the trip threshold.
(misc. hardware fault #2)
48 The main contactor opened If condition persists Self-clearing
unexpectedly. (misc. hardware contact an authorized
fault #3) Field Service Shop
"bad The selected weld mode does If condition persists Press the Mode
nodeʼ not exist in the weld table that is contact an authorized Select button to
“####” presently loaded in the machine. Field Service Shop select a different
mode