Elitegroup G410 - Manual (Page 13)

5
¾ The cord set must be UL Listed and CSA Certified.
¾ The minimum specifications for the flexible cord
are No. 18 AWG.
B. For Japan:
¾ All components of the cord set must bear a “PSE”
or “ T ” mark and registration number in
accordance with the Japanese Dentori Law.
¾ The minimum specifications for the flexible cord
are .75m ㎡ conductors.
C. For Other Countries:
¾ The cord set fittings must bear the certification
mark of the agency responsible for evaluation in a
specific country.
¾ The flexible cord must be of a HAR (harmonized)
type H03VV-F.
¾ The cord set must have a current capacity of a
least 2.5 Amperes and voltage rating of 125 or
250 Vac.
18. When using your telephone equipment, basic safety
precautions should always be followed to reduce the risk of
fire, electric shock and injury to persons. These precautions
includes the following:
¾
Do not use this product near water, for example, near a
bathtub, washbowl, kitchen sink or laundry tub, in a wet
basement or near a swimming pool.
¾ Avoid using a telephone (other than a cordless type) during
an electrical storm. There may be a remote risk of electric
shock from lightning.
¾ Do not use the telephone to report a gas leak in the vicinity
of the leak.
¾ Use only the power cord indicated in this manual.
19. Do not use the AC adapter near open water or other liquids.
Never spill liquid into the AC adapter.
20. Laser Warning: Laser Class I Product Caution - Invisible laser
radiation when open avoid exposure to beam.
21. Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the
manufacturer's instructions. Never remove the battery pack
while the power is on as this may result in data loss when the