Elitegroup 910 - Manual (Page 34)

28
For example, if the message “Express protect error writing Drive x” is
displayed, the user has to change the write protect switch setting on the
memory card. To change the switch setting, (a) eject the card, (b) change
the switch setting, and (c) re-insert the card.
Always disconnect all telephone lines from the wall outlet before
servicing or disassembling this equipment. To reduce the risk of fire, use
only No. 26 AWG or larger telecommunication line cord.
Power Saving Modes
This section contains information on the Notebook’s power system,
including the AC Adapter, the battery system, recharging the battery, and
tips for conserving battery power.
The power system is comprised of two parts, the AC Adapter and the
battery system. The AC Adapter converts AC power from a wall outlet to
the DC power required by the computer.
The Battery Power System
Before using the computer on battery power for the first time, check the
battery status icon on the Windows Toolbar to make sure the battery is
fully charged.
See Battery Status later in this section for a description and explanation of
the Windows Battery icon. Charging the battery takes about 4 hours to
charge when the system is in off state. If possible, always charge the
battery completely.
If you use the battery so frequently that it exceed more than
20 times by fully discharging/charging in a single month
alone, we recommend you to perform the “Battery
Calibration” process every 3 months to maintain the battery
life. Please refer to the topic on “Battery Calibration”
describing how to calibrate your system battery discussed on
the latter part of this chapter.
If you discover the battery life is getting shorter, please
perform the “Battery Calibration” process immediately.
Removing the Battery Pack
To remove the battery pack from its compartment, please refer to Chapter
Three, Inserting and Removing the Battery Pack.