Elitegroup 910 - Manual (Page 26)

20
Never turn off or reset your Notebook while the hard disk is in
use and the CD-ROM status icon is lit; doing so can result in
loss or destruction of your data. Always wait at least 5
seconds after turning off your Notebook before turning it back
on; turning the power on and off in rapid succession can
damage the Notebook’s electrical circuitry.
Turning On Your Notebook Computer
Turn on your Notebook by pressing the power button. Hold the button
down for a 1 or 2 seconds and release. The Power-On Self Test (POST)
runs automatically.
After the POST is completed, the computer reads the operating system
from the hard disk drive into computer memory (this is commonly
referred to as “booting” a computer). If your OS (Operating System such
as Windows XP etc) is installed, it should start automatically.
To turn the Notebook off, save your work and close all open applications,
click on Start, then select the “Turn off the computer”. A selection box
will be displayed and click on the “Turn Off” button to shut down your
computer.
When your computer hangs up, press the power button for 4-
6 seconds to shut down the computer.
Operating on Battery Power
Your computer comes with a rechargeable battery pack that lets you
operate the computer without an external power source. When the battery
pack is fully charged, you can operate the computer for approximately 2.5
hours under the following conditions:
•
The battery pack initially has a full charge.
• No peripheral devices are installed.
• The disk/DVD-ROM drives run no more than 10% of the time.
Only use batteries that are approved by an authorized dealer
for this model only. All batteries are not the same and
therefore should not be treated as such. Using the wrong
battery could cause serious damage to your computer and
yourself through toxic emissions.