Elitegroup A980 - Manual (Page 100)

88
Upgrading your Memory
Refer to the following instructions and illustration for information on upgrading your DeskNote's
memory.
1. Turn off the computer and disconnect the AC adapter and all peripherals.
2. Turn the DeskNote over so that the rear ports are facing you and locate the memory module
compartment.
3. Remove the screws that secure the RAM module compartment cover and set it aside in a safe
place.
4. Remove the compartment cover and then angling it up and out.
5. If you need to install a higher capacity module, gently push the edge clips on both sides to
release the module. Angle the card slightly upward and gently slide it from its edge
connector slot. Store the card in the anti-static bag that contains your new module(s).