Elitegroup 557 - Manual (Page 12)

8.
9.
10.
11.
12.
13.
b.
c.
d.
e.
f.
14.
15.
16.
17.
A.
B.
Place the power cord in such a way that people can not step on it. Do not place anything
on top of the power cord.
All cautions and warnings on the equipment should be noted.
If the equipment is not use for a long time, disconnect the equipment from the main power
outlet to avoid being damaged by transient overvoltage.
Never pour any liquid into the opening, this could cause fire or electrical shock.
Never open the equipment. For safety reason, the equipment should only be opened by a
qualified service personnel.
If on the following situations arises, get the equipment checked by a service personnel:
a. The Power cord or plug is damaged.
Liquid has penetrated into the equipment.
The equipment has been exposed to moisture.
The equipment has not worked well or you cannot get it work according to the user's
manual.
The equipment has dropped and damaged.
If the equipment has obvious sign of breakage.
Do not leave this equipment in an environment unconditioned, storage temperature above
60
°C (140°f), it may damage the equipment.
The unit can be operated at an ambient temperature of max. 35 °C.
The sound pressure level at the operators position according to IEC 704-1: 1982 is equal or
less than 70 dB(A).
Power Cord Requirements
The power cord set used with the AC adaptor must meet the requirements of the country
where you use the AC adaptor, whether it is 100-120 or 200-240 Vac. The following
information explains the requirements for power cord set selection.
• The cord set must be approved for the country in which it is used.
• The appliance coupler must have a configuration for mating with a
CEE22/EN6032/IEC 320 appliance inlet.
For U.S. and Canada:
• The cord set must be UL Listed and CSA Certified.
• The minimum specifications for the flexible cord are No. 18 AWG.
For Japan:
2