Elitegroup A960M-MV (V1.0A) - Manual (Page 47)

Step1. InstĂůůĂƟŽn Žf the CPU and CPU CŽŽůer:
Hardware InstaůůaƟŽn Guide
InstaůůaƟŽn Steps
1-1. Position lever at a 90 degree
angle.
Step2. InstaůůaƟŽn Žf DeŵŽrLJ DŽduůes:
2-1. Unfasten the latches on each side
of the DIMM slots.
Step3. InstaůůaƟŽn Žf DŽtherďŽard:
3-1. Replace the back I/O plate of the
case with the I/O shield provided in
motherboard’s package.
1-2. Locate the CPU cut edge (the
corner with the pin hold noticeably
missing). Align and insert the CPU
correctly, then press the metal lever
back into its original position.
1-3. Apply thermal grease on top of the
CPU. Put the CPU Fan down on the
retenƟon module and Ňip the levers
over the heat sink in place.
1-4. Connect the CPU cooler power
connector to the CPU_FAN connector.
2-2. Firmly press the DIMM down unƟl it
seats correctly. Make sure the slot
latches are levered upwards and latch
on the edge of the DIMM.
3-2. Place the motherboard within the
case by posiƟoning it into the I/O plate.
Secure the motherboard to the case
with screws.
English
43