DataComm 45-0051-WH Expandable Media Box with Duplex Receptacle - Manual (Page 7)

Installation Diagram – Front View Installation Diagram – Back View
WARNING
 DataComm Electronics’ products shall be installed and used only as indicated in DataComm Electronics’ product instruction sheets.
 Instruction sheets are available online at www.datacommelectronics.com.
CAUTION
 For shock protection, this device must be properly grounded.
 Use copper wire only with this device.
IMPORTANT INSTRUCTIONS
 Read and understand all instructions.
 Follow all warnings and instructions marked on the product.
 Do not use this product near water, for example near a bath tub, wash bowl, kitchen sink, laundry tub, in a wet basement, or near a
swimming pool.
 SAVE THESE INSTRUCTIONS.
Instruction / Installation Sheet
Expandable Media Box
with Duplex Surge Suppressor
Part # 45-0061-WH
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.DataCommElectronics.com
Parts Included:
• Expandable Media Box with Expandable Cavity
• Old Work Electrical Box with four (4) Mounting Screws
• 15 Amp/125 Volt Duplex Surge Suppressor
• Flexible Pass-Through Accessory Plate
• Six (6) Port Keystone Accesory Plate
• Blank Accessory Plate
Tools Required:
• Drill with Phillips Bit or Phillips Head Screw Driver
• Pen or Pencil
• Sheetrock Saw or Utility Knife
• 6 Ft. Tape Measure
Use the Exandable Media Box with Duplex Surge Suppressor to install low voltage cables behind your HDTV or other display
device. The Media Box can be installed with the receptacle on the left or right side (see Installation Diagram below).
Features of the Expandable Media Box with Duplex Surge Suppressor include:
• Compact size fits behind small and large TV’s
• Expandable Cavity adds accessible storage space inside of the wall
• HDTV/display device plug recesses completely into the wall when plugged into the Media Box
• Flexible Pass-Through Accessory Plate conceals low voltage pass-through opening
Page 1 of 3 05/01/2014
Concealed Wiring
Hidden
Storage
Cavity
(hidden in wall)
Flat Screen TV
Flat Screen TV
Concealed Wiring
(hidden in wall)
Hidden
Storage
Cavity
Surge Suppressor Specifications:
Inside the Hubbell Surge Protection Receptacles are two 22mm square MOV’s providing 240 joules /15000A of surge protection for
each mode. Meets UL Standards 1449 3rd Edition and 498: CSA Certified. 1449 3rd Edition and 498: CSA Certified. Damage-alert
alarm sounds when surge protection is no longer functioning and keeps sounding until the muting screw is utilized or the receptacle is
replaced. Power-on indicator light verifies instantly that power is available at the receptacle and the suppression circuit is fully functional;
light off means power has been interrupted, flashing light indicates surge protections circuitry has been damaged. Replacement surge
suppressor can be purchased from DataComm Electronics or an authorized Hubbell Wiring Device distributor.