DataComm 45-0071 Recessed Low Voltage Mid-Size Plate with Duplex Receptacle - Manual (Page 7)

IMPORTANT INSTRUCTIONS:
This product is designed for retrofit work only because the electrical outlet box cannot be attached to a stud.
WARNING:
Before running 12/2 w/ground UL approved building to the Recessed Low Voltage Mid-Size Plate with 20 Amp Duplex Receptacle, be sure the
power is off by switching the circuit breaker to off or removing the fuse(s). Test the power to make sure the power is off.
Be sure to install the Mid-Size Plate with Duplex Receptacle in accordance with the National Electrical Code (NEC) and local codes.
Figure 1 – Front View Figure 2 – Back View
Concealed Wiring
(hidden in wall)
Flat Screen TV
Concealed Wiring
(hidden in wall)
Flat Screen TV
Instruction / Installation Sheet
Recessed Low Voltage Mid-Size Plate
with 20 Amp Duplex Receptacle
Part # 45-0072-WH
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.DataCommElectronics.com
Parts Included:
• Recessed Low Voltage Mid-Size Plate
• Steel Electrical Box
• 20 Amp/125 Volt Tamper Resistant Duplex Receptacle
• Four (4) Screws
Tools Required:
• Drill with Phillips Bit or Phillips Head Screw Driver
• Pen or Pencil
• Sheetrock Saw or Utility Knife
• 6 Ft. Tape Measure
Use the Recessed Low Voltage Mid-Size Plate with 20 Amp Duplex Receptacle to install low voltage cables
behind your HDTV or other display device. The plate can be installed upright or sideways (see Figures 1 & 2).
Features of the Recessed Low Voltage Mid-Size Plate with 20 Amp Duplex Receptacle include:
• Compact size fits behind small and large TV’s
• HDTV/display device plug recesses completely into the wall when plugged into the Mid-Size Plate
• 20 Amp Duplex Receptacle and Steel Electrical Box for commercial requirements
• Low voltage flexible screen cover conceals low voltage pass-through opening
Page 1 of 3 11/15/13