DataComm 45-0071 Recessed Low Voltage Mid-Size Plate with Duplex Receptacle - Manual (Page 5)

2-Pole 3-Wire
Grounded
60 Hz
Total Maximum
Surge Dissipation
Maximum Surge
Current
Surge Protection
Clamping
Response Time
15A-125V 480 Joules 15,000 Amps
Hot/Neutral,
Hot/Ground,
Neutral/Ground
1 Nanosecond
Fig. 5
Fig. 6
888.223.7977
www.datacommelectronics.com
Figure 5
Now use the four screws provided to secure the electrical outlet box to the mounting studs on the backside of the
Mid-Size Plate.
Figure 6
Important: Before installing the Recessed Mid-Size Plate with Duplex Receptacle into the template opening, make sure
to pull your low voltage cables through the low voltage cable opening. If you have more than 4 cables you can remove
the flexible plate that seals the low voltage cable opening. This allows for more cables to be pulled through the opening.
After you have pulled your low voltage or A/V cables through the low voltage opening: Start with the bottom of
the Recessed Mid-Size Plate and slowly slide the plate into the opening. Swing the top of the plate into position until the
entire Mid-Size Plate is flush with the wall. Now screw down the screws with wings; these wings fasten tightly against the
back of the drywall.
Figure 7
Your new 45-0081-WH Recessed Low Voltage Mid-Size Plate with Duplex Surge Suppressor is now installed and ready
for the flat panel TV mount to be installed. Install your flat panel TV mounting bracket per the flat panel TV bracket
manufacturer’s instructions.
Installation / Instruction Sheet 45-0081 (Continued)
Fig. 7
Surge Suppressor Specifications
Inside the Hubbell Surge Protection Receptacles are two 22mm square MOV’s providing 240 joules /15000A of surge protection for each mode. Meets
UL Standards 1449 3rd Edition and 498: CSA Certified.
Damage-alert alarm sounds when surge protection is no longer functioning and keeps sounding until the muting screw is utilized or the receptacle is
replaced. Power-on indicator light verifies instantly that power is available at the receptacle and the suppression circuit is fully functional; light off means
power has been interrupted, flashing light indicates surge protections circuitry has been damaged.
Replacement surge suppressor can be purchased from DataComm Electronics or an authorized Hubbell Wiring Device distributor.
Fig. 3
Fig. 4
Figure 3
Run the source of power to the included electrical outlet box.
Figure 4
Using the supplied Duplex Surge Suppressor, connect the Recessed Mid-Size Plate to the piece of 12/2 or 14/2 with
ground UL approved electrical building wire that you have pulled from a power source. Strip off approximately 3 inches
of the outer jacket of the UL approved building wire. Be careful not to cut the jacket of the inner wires. Connect the hot
line (black) wire to the brass colored terminal screw and neutral (white) wire to the silver colored terminal screw. Be sure
to connect the grounding (green) or bare grounding wire to the green colored terminal screw (see Fig 3). Once you
have wired the supplied Duplex Surge Suppressor, screw the Duplex Surge Suppressor receptacle into the electrical
outlet box until the receptacle is firmly secured.
Page 2 of 3 10/1/12