Burcam 450475 EASYFLUSH TOILET SYSTEM 1/2HP 115V - Manual

1
www.burcam.com
INSTALLATION
INSTRUCTIONS
Please read these
instructions carefully.
Failure
to comply
to instructions and
designed operation
of this system,
may void the
warranty.
Your pump has been carefully packaged at the factory to prevent
damage during shipping. However, occasional damage may
occur due to rough handling. Carefully inspect your pump for
damages that could cause failures. Report any damage to your
carrier or your point of purchase.
MODEL
450475
EASY FLUSH
SYSTEM
2190 Dagenais Blvd. West TEL: 514.337.4415
LAVAL (QUEBEC) FAX: 514.337.4029
CANADA
H7L 5X9
[email protected]
INITIAL START UP PROCEDURES :
1. Inspect the pump and the sewage tank for
any obvious condition that may necessitates
cleaning, correction, adjustement or repair.
2. Assure that the pump is secure and vertical
for proper operation.
3. Assure that there is adequate clearance from
any combustible materials or structure. Stored
materials must be kept away from the pump.
4 . Assure that the motor is securely plugged into
a proper ‘GFCI’ electrical outlet.
5 . Test the ‘GFCI’ outlet by pressing its test
switch. This should prove that the outlet
is energized and will trip off to protect
against a ground fault. Be sure to reset
the ‘GFCI’ by pressing its reset switch.
(Repeat this step monthly)
6. Lift the fl oat to assure that the pump will
start when required. (Step 7 below will test
submersible pumps with enclosed fl oats)
7. Pour pails of water in the sewage tank to turn
the pump on. Assure that any
check valve present
will permit the sewage
to fl ow.
8. Observe that the
plumbing can pump
the sewage safely
out of the residence.
(Repeat this step monthly)
© 2013 BUR-CAM Printed in Canada 450431