Brocade Converged 10GbE Switch Module for IBM BladeCenter IBM BladeCenter at-a-glance guide - Manual (Page 4)

Brocade Converged 10GbE Switch Module for IBM BladeCenter 4
The converged switch modules have the following features:
Eight external 10 Gb Converged Enhanced Ethernet ports 
Eight external auto-negotiated Fibre Channel ports (2 Gbps, 4 Gbps, or 8 Gbps) 
14 internal auto-negotiated 10 GbE ports (1 Gbps or 10 Gbps) 
Two internal full-duplex 100 Mbps Ethernet interfaces for management purposes 
One external RS232 console port with a mini-USB interface for serial console management

One external 10/100/1000 Mb RJ45 Ethernet copper port for management 
CEE features

Priority-based Flow Control (PFC): IEEE 802.1Qbb 
Enhanced Transmission Selection (ETS): IEEE 802.1Qaz 
Data Center Bridging eXchange (DCBX) 
Layer 2 features 
Layer 2 Virtual Local Area Networks (VLANs): 4096 
VLAN Encapsulation 802.1Q 
Rapid Spanning Tree Protocol (RSTP) 
Multiple Spanning Tree MSTP (802.1s): 16 instances 
Link Aggregation Control Protocol (LACP) IEEE- 802.3ad 
Brocade enhanced frame-based trunking 
Advanced PortChannel hashing based on Layer 2, 3, and 4 information 
Pause Frames (802.3x) 
Storm Control (unicast, multicast, and broadcast) 
Address Resolution Protocol (ARP) RFC 826 
Layer 2 security 
Ingress Access Control Lists (ACLs) 
Standard and extended Layer 2 ACLs 
VLAN-based ACLs (VACLs) 
Port-based ACLs (PACLs) 
ACL statistics 
Port-based Network Access Control: IEEE 802.1X 
Layer 2 Quality of Service (QoS) 
Eight priority levels for QoS 
IEEE 802.1p Class of Service (CoS) 
Eight hardware queues per port 
Per-port QoS configuration 
CoS trust: IEEE 802.1p 
Per-port Virtual Output Queuing 
CoS-based egress queuing 
Egress strict priority queuing 
Egress port-based scheduling: Weighted Round-Robin (WRR) 
Layer 3 features

Static IP routes 
External Fibre Channel ports that can operate as F_ports (fabric ports), FL_ports (fabric loop ports), 
or E_ports (expansion ports)