Anthro Convoi Base Unit Assembly Instructions - Manual (Page 3)

steP 1
connect the Foot to the leg column
¡ Attach one foot to the bottom of the leg column using four
cap screws. Loosely install each screw then tighten them all.
¡ Repeat for the second leg column.
cap screw
325-5264-00
3/16" Hex Key
375-5028-00
steP 2
Attach the casters
¡ Depress the tab on the green-tabbed Swivel
Lock Casters. While holding the top of the caster,
rotate the wheel until it clicks into the locked position.
This locks the swivel and makes the caster easier to install.
¡ Install the two Swivel Lock Casters into the same foot by
shoving the caster stem into the hole.
¡ Install the two Total Lock Casters (silver tab) onto the second foot.
steP 3
install the cross tubes
¡ Align one cross tube with one leg assembly so
one hole on the leg assembly lines up with one
end of a cross tube. Using the Anthro driver,
loosely attach the cross tube to the leg assembly
with a bolt. Loosely attach that cross tube to the
other leg assembly
¡ Repeat to install the second cross tube. Once all
four bolts are installed, tighten them all the way.
cross tube
swivel lock casters
(green tab)
swivel lock casters
(green tab)
bolt
325-5194-00
steP 4
relocate the cable blade
¡ The Cable Blades come installed in your Convoi legs. If you'd
like to move them, first lubricate them with dish soap or
another lubricant, then pull them out gently. (Grab them with
pliers if that helps.) Reinstall as desired.
top View
rubber cable blade
congrAtulAtions! your Assembly is comPlete!
Next, review the Assembly Sequence notes on each Convoi accessory instruction to determine your next step.