Anthro Tablet Charging Carts Owners Manual - Manual (Page 3)

Owner's Manual for Anthro Tablet Charging Carts 3
Loading Devices, Cable Management
In the front User area of the cart
• Starting at the outside of each shelf, route one charging cord
along the top of each divider. Make sure that the cord end
that goes into the devices is at the front of the bay and that
the power end goes to the back panel and into the IT area.
• Leave enough slack in front
(approximately 4.5”; use
the height of the divider
as a measuring stick) so
users can plug in the device
without straining the cord.
[Image A]
• Weave the cord around the
short hook at the front of
the divider, then back and
forth through the three long
channels along the top of
the divider, including the
center channel that’s lower
than the others, and finally
through the short hook
at the back of the divider.
[Image B and C]
• Feed the rest of the cord
into the IT area. [Image D]
• From the front of the bay,
give a gentle tug on the
cord to make sure it’s held in
place. If it’s loose, then the
cord isn’t fully inserted into
each channel.
A
B
C
D
In the back IT area of the cart
• Plug in each power adapter,
then poke cable clips into
the holes in the pegboard
divider – one cable clip per
adapter should do. You'll
coil each cord and secure
it into the cable clip before
plugging it into the adapter.
[Image E]
• A great technique for coiling
cables is to wind them
around two fingers before
securing them in the cable
clips. [Image F] Be sure to
leave enough slack in your
cord so it can plug into the
adapter.
• Plug the cord into the
adapter. [Image G]
• For devices with large power
adapters, first bundle the
cord and adapter together
to save space, then plug
in the adapter. Finally, use
cable clips to secure the
bundle to the pegboard
divider.
• Turn the power switch to
the OFF position before
plugging the cart into the
wall. [Image H]
E
F
G
H