STI 34104 - Manual (Page 2)

Enroll a SENSOR:
These steps should be followed to program devices into the RECEIVER.
1. Plug antenna into red connector on the RECEIVER.
2. Plug in the RECEIVER and wait until the start up tone finishes.
3. Immediately press (RECEIVER will beep) and hold the grey button until you hear a second
single beep (approx. 2-3 seconds), then let go of the button.
4. The red LED should be solid. You now have 60 seconds to enroll all SENSORS.
5. Trigger a SENSOR (examples: open cover, separate reed switch, tilt, etc.). When the
wireless signal is received the green LED on the RECEIVER flashes and the RECEIVER
makes a double beep. If you have additional sensors, repeat this step. When you have
enrolled all SENSORS go to Step 6.
6. To exit enroll mode, press and release the button on the RECEIVER.
7. Test a SENSOR by triggering the SENSOR. The RECEIVER should beep once, twice, etc.
then make the alert tone. If your RECEIVER does not respond correctly after these steps,
follow the steps in the section named “Clearing the RECEIVER memory” and “Enroll a
SENSOR.”
RECEIVER Modes of Operation:
Normal Operating Mode
When signal is received from a device, a short alert tone will play and the red LED on the
RECEIVER will flash (until a restore signal is received from the device and the RECEIVER is
reset). The green LED may flash periodically to indicate routine signals are being received. This
does not mean a device has been triggered.
To reset the RECEIVER, press and release the button. If more than one SENSOR is being used
and is triggered, the RECEIVER will beep twice, three times, etc. before playing the alert tone
to indicate which SENSOR was detected by the RECEIVER.
Temporary (8 Hours) and Permanent Silent Modes
These modes may be entered ONLY while the RECEIVER is in normal operating mode. Once
in silent mode, if there is a power outage, the RECEIVER will stay in silent mode until exited.
While in silent mode, the red LED will change from continuous to flashing when a transmission
is detected.
Entering Temporary Silent Mode - Press and hold the button on the RECEIVER until you hear
a second beep (approximately 3 seconds). Red LED will be on solid.
Entering Permanent Silent Mode - Press and hold the button until the RECEIVER makes a
series of two short beeps (approximately 6 seconds). Red LED will be on solid.
Exit Silent Mode - Push and hold the button until you hear a single beep to return to normal
operating mode.
— 2 —