STI 34104 - Manual

— 1 —
Installation and Operation Manual
STI 4-Channel Receiver
Thank you for purchasing the STI 4-Channel Receiver. Your satisfaction is very important to us.
Please read this manual carefully to get the most from your new product.
How the Product Works:
STI offers multiple wireless products designed to alert you of several different conditions. The
4-Channel Receiver allows you to monitor up to 4 different STI devices at a single convenient
location. The STI wireless alert series uses a system to ensure other non STI devices are
enrolled or detected (eliminating accidental enrollment, alerts or crosstalk). The STI 4-Channel
Receiver allows you to sound a chime, mute the chime to monitor in silence mode or turn on
an external 12 VDC output. It also uses alert latching which will keep the alert indicator on if
the SENSOR is still in the alert state.
Before You Start:
Refer to this drawing to become familiar with all parts.
Model: STI-34104
STI-30104
LAMP CONTROLLER
(OPTIONAL)
AC ADAPTER
GREEN
LED
75 mA
OUTPUT
RECEIVER ANTENNA
SPEAKER
STI-34104
INDOOR RECEIVER
BUTTON
RED LED
SENSOR TRANSMITTER CAP
SENSOR TRANSMITTER BASE
MOUNTING
TUBE CAP
WALL MOUNT (INCLUDED)
NOT NEEDED FOR POLE
MOUNT INSTALLATION
2 “C” BATTERIES
(NOT INCLUDED)
SENSOR TRANSMITTER
MOUNTING TUBE
MOUNTING STAKE
SENSOR TRANSMITTER
BOTTOM
SENSOR TRANSMITTER
MOUNTING
TUBE CAP
MOUNTING TUBE
MOUNTING STAKE
SENSOR TRANSMITTER BOTTOM
SCREWS
RECHARGEABLE NiMH BATTERIES
H L
SENSITIVITY JUMPERS
(SOLAR TYPE)
SENSITIVITY JUMPERS
(BATTERY TYPE)
H L
FINGER
NOTCHES
REMOVE PLASTIC TAB
FROM BATTERIES
DRIVEWAY
3’OR
LESS
25' OR MORE
PLACE SENSOR
TRANSMITTER 3' OR
LESS FROM EDGE OF
DRIVEWAY AND 25'
OR MORE FROM STREET.
12’
MAX
DRIVEWAY
PLACE SENSOR
TRANSMITTER 3' OR
LESS FROM EDGE OF
DRIVEWAY AND 25+
FEET OR MORE FROM
STREET.
25' OR MORE
3' OR
LESS
12'
MAX
+
+
-
B
DETAIL B
SCALE 2:1
B
C
H L
-
+
+
-
B
-
FINGER NOTCHES
DO NOT
PULL ANTENNA!
WALL MOUNT (INCLUDED)
NOT NEEDED FOR POLE
MOUNT INSTALLATION
SENSITIVITY
ADJUSTMENT
SENSITIVITY
ADJUSTMENT
4-Channel Receiver STI-34104
Receives up to 4 different STI Wireless Alert Series Sensors
Clearing the RECEIVER memory:
Follow before using the RECEIVER for the first time or if RECEIVER does not respond as
expected. Programmed devices will always remain in memory, unless this procedure is
followed (even if power is lost).
1. Be sure the antenna is in the red connector on the RECEIVER.
2. Disconnect power from RECEIVER and wait for 15 seconds.
3. Reconnect power to the RECEIVER, the RECEIVER will make a start up tone and the green
LED will flash.
4. Immediately press (RECEIVER will beep) and hold the grey button. You will hear a second
single beep (approx. 2-3 seconds). Continue to hold (approx. 3 more seconds) until you
hear a double beep, then let go of the button. The red LED should be solid.
5. Press and hold the button again until you hear a long tone, then let go of the button.
NOTE: if you do not get the long tone (example, short beep) then begin again at step 2 until
the long tone is heard.
6. Disconnect power and wait another 15 seconds prior to following ENROLL A SENSOR.