NcSTAR AQPTFLG - Manual (Page 3)

ZEROING:
 WHEN OPERATING ANY TYPE OF FIREARM ALWAYS USE PROPER EYE AND
EAR PROTECTION. BE SURE TO USE YOUR FIREARM IN AN AREA THAT IS
PERMISABLE UNDER LOCAL, STATE, AND FEDERAL LAW.
The first step to help make the zeroing process easy, remove the Front Laser Cap from the Laser Assembly. Make
sure that the Green Laser Assembly is screwed into the main body with the Orientation Arrows [FIGURE 2] (in the
corner) are as close as to being plumb and level.
FIGURE 2
Set up a target at the desired distance. Begin the zeroing process by first turning your laser to the ON position
by pushing the rear slide switch to the left. Place your laser beam on the center of the target. Be sure to secure
the firearm so that it will not move when fired. Fire a few carefully aimed shots to see where the projectiles
group/impact on your target in relation to the laser beam.
With the firearm unloaded, clear, and safe; adjust the laser’s Windage and Elevation Allen head set
screws [Figure 2] to match the shot grouping using the provided Allen wrenches. After adjusting the laser beam
to match the location of the shot grouping, fire a few more shots to confirm zero. If the laser is still not zeroed
then follow the same procedure again making small adjustments until the desired level of accuracy is achieved.
Using a laser bore sighter will also make the zeroing process a little easier. Another quick Tip is to zero the laser
beam to the iron sights of the firearm if they are available.
SPECIFICATIONS:
Wavelength: 532 nm
Maximum Output Power: <5mW
Operating Voltage: 3V DC
Battery type: CR123A lithium (only one required)
Line Width: <0.1 nm
Beam Divergence: <1mrad
Beam diameter: <1 mm
Operation Current: <300mA
Operating temperature: 59 – 95 degrees Fahrenheit
 SPECIAL NOTE: THE GREEN LASER ASSEMBLY WILL ONLY FUNCTION UNDER
THE TEMPERATURES LISTED ABOVE. THE GREEN LASER MAY NOT
FUNCTION IN EXTREME COLD OR EXTREME HEAT. ONCE THE UNIT HAS
RETURNED TO NORMAL TEMPERATURES IT WILL FUNCTION PROPERLY.