NcSTAR VDGRLB - Manual (Page 5)

With some firearms it may not be possible to use a bore sighting device. In this case it will be necessary to
use a more traditional method of zeroing.
CAUTION: WHEN OPERATING ANY TYPE OF FIREARM ALWAYS USE PROPER EYE AND EAR
PROTECTION. BE SURE TO USE YOUR FIREARM IN AN AREA THAT IS PERMISABLE UNDER
LOCAL, STATE, AND FEDERAL LAW.
1. From a steady and supported shooting position (such as a shooting bench with a rifle rest or sand
bags) take careful & consistent aim and slowly fire three to five round groupings at a target.
2. Observe where the bullets have struck the target and adjust windage and elevation as necessary
until your point of aim matches your point of impact.
3. Your firearm and Green Dot sight are now zeroed.
ZEROING YOUR RED LASER SIGHT
CAUTION: AVOID DIRECT EYE EXPOSURE TO LASER BEAM!
ADJUSTING THE LASER WINDAGE AND ELEVATION:
The built in Red Laser on your VDGRLB is adjustable for both windage and elevation. The Laser Windage
Adjustment Set Screw and Laser Elevation Adjustment Set Screw are both found on the Red Laser Housing
located at the very top of the optic, and can be adjusted by using the provided 1.5mm Allen Wrench.
To adjust the Laser Elevation Up, turn the Laser Elevation Adjustment Set Screw Clockwise, and to adjust
the Laser Elevation Down turn Laser Elevation Adjustment Set Screw Counter-Clockwise.
To adjust the Laser Windage Left, turn the Laser Windage Adjustment Set Screw Clockwise. To adjust the
Laser Windage Right, turn the Laser Windage Adjustment Set Screw Counter-Clockwise.
NOTE: For zeroing/sighting in your Red Laser Sight, please use the same instructions above titled SIGHTING
IN YOUR GREEN DOT SIGHT.
BATTERY INSTALLATION
Your Green Dot with Integrated Red Laser optic comes ready to use with a pre-installed CR2032 battery
from the factory. If the battery life expires or your optic or laser no longer illuminates, follow these simple
instructions: