NcSTAR DGAB - Manual (Page 3)

The Reflex Sight is designed to fit both Weaver style & Picatinny rails. Turn the thumb nut on the mount counter-
clockwise until you feel some resistance. Push the thumb nut against the side of the mount to push the internal rail clamp
to the opposite side. Place the mount onto the optics rail of your firearm. Make sure to align the thumb nut bolt (acts as a
recoil stud) with one off the cross slots on your optics rail. With the reflex sight sitting flush with the top of your optics
rail, turn the thumb nut clockwise until the reflex sight is properly secured to your firearm. Removing the reflex sight from
your firearm is in the reversed procedure.
WINDAGE AND ELEVATION ADJUSTMENT:
 BEFORE YOU MAKE ANY WINDAGE OR ELEVATION ADJUSTMENT, YOU MUST FIRST LOSEN
(COUNTER-CLOCKWISE) THE TWO SLOTTED SET SCREWS LOCATED IN THE REAR (FACING
THE SHOOTER) OF THE REFLEX SIGHT. WHEN YOU HAVE FINISHED MAKING YOUR
WINDAGE AND ELEVATION ADJUSTMENTS, TIGHTEN (CLOCKWISE) THE TWO SLOTTED
SCREWS TO LOCK THE RETICLE IN PLACE.
 WHEN OPERATING ANY TYPE OF FIREARM ALWAYS USE PROPER EYE AND EAR
PROTECTION. BE SURE TO USE YOUR FIREARM IN AN AREA THAT IS PERMISABLE UNDER
LOCAL, STATE, AND FEDERAL LAW.
BEFORE you make any Windage or Elevation adjustments, use the supplied flat blade screw driver to loosen
(counter-clockwise) the two slotted Locking Set Screws at the rear of the reflex sight (facing the shooter).
Loosening the two locking set screws, will unlock the reticle plate so that you will be able to make the
necessary windage and elevation adjustments.
The Elevation Screw is located at the top of the reflex sight near the back edge. Turning the elevation screw
clockwise will lower the Green dot Down (raising the point of impact UP). Turning the elevation screw
counter-clockwise will raise the Green dot Up (lowering the point of impact DOWN).
The Elevation Screw is located at the right side of the reflex sight near the back edge. Turning the Windage
screw clockwise will move the Green dot Left (moving the point of impact to the RIGHT). Turning the
elevation screw counter-clockwise will move the Green dot Right (moving the point of impact to the LEFT).
After you are satisfied with the Green Dot’s Zero, tighten (clockwise) the two slotted Locking Set Screws
located at the rear of the reflex sight. This will lock the reticle plate in place, preventing the Green dot from
changing its Zero under recoil.
 If you are not sure about any of the procedures in this manual, always seek the help of a
qualified professional to avoid damage to your scope and your firearm.