NcSTAR D3ARSGQLR2 - Manual (Page 6)

CARE AND MAINTENANCE
Your Green Dot Optic is a factory sealed unit, please do not attempt to take it apart or clean it
internally.
The exposed Optical lens surfaces will perform their best if they are routinely cleaned with a lens
brush and the lens cloth provided with your sight. For a deep cleaning, you can also use high quality
camera lens paper and camera lens cleaning solutions. Never use any other type of materials or
solvents other than those designed specifically for Optical lenses to avoid damaging your sight.
Clean the outer edge of the lens cavity first with cotton swabs, clearing as much debris and dust as
possible. Then, gently clean the lenses using a circular motion starting in the center and ending at
the edges. Do not rub the lenses continually; simply wipe in small circular patterns.
Maintain the exterior surfaces of the scope by removing dirt or sand by using a soft brush or a clean
soft dry cloth. You can also use a silicone treated cloth to restore luster of the Optic’s body and
protect the scope against corrosion.
Be careful not to touch any of the lenses with the silicone cloth.
When not in use, always store your sight in a dry place.
 IF YOU ARE NOT SURE ABOUT ANY OF THE PROCEDURES IN THIS MANUAL, ALWAYS
SEEK THE HELP OF A QUALIFIED PROFESSIONAL TO AVOID DAMAGE TO YOUR OPTIC
AND YOUR FIREARM.
LASER SPECIFICATIONS:
Red Laser Specifications:

Laser Class: Class IIIa

Maximum Output Power: <5mW

Wavelength: 635-655nm

Operating Temperature: 59 – 95 degrees Fahrenheit

Battery Type: CR123A

Operating Voltage: 4.5V DC

Operation Current: <30mA