NcSTAR SEC3RSR3942G - Manual (Page 2)

2
MOUNTING PROCEDURE
Your scope mount is the link between your firearm and your optics. It is very important to have a
solid connection between the two in order to ensure proper function of all the components. You
should place your firearm on a secure platform, such as a gun vise, before performing any of the
following procedures.
 CAUTION: CAREFULLY FOLLOW ALL OF THE MOUNTING PROCEDURES. FAILURE
TO DO SO CAN CAUSE DAMAGE TO YOUR SCOPE OR FIREARM
 CAUTION: BE SURE THAT YOUR FIREARM IS UNLOADED AND POINTED IN A SAFE
DIRECTION. PRACTICE SAFE FIREARM HANDLING PROCEDURES AT ALL TIMES.
MOUNTING THE SCOPE TO THE WEAVER/PICATINNY RAIL
Follow these mounting instructions:
1. Begin by loosening the Thumb Nuts (counter-clockwise) on the right side of the mount.
2. With the Mount Thumb Nuts loosened, the Mount Rail Clamp should slide out wider from the
base mount. This will allow you to place the scope onto a Weaver or Picatinny rail. You want
to position the scope, so that when you have your firearm shouldered with a proper cheek
weld you have the scope set the proper distance from your eye. Positioning the scope with the
proper eye relief will give you a full field of view through the scope.
3. Once you have the scope properly positioned on your firearm, slide the Mount Rail Clamp
against your firearm’s optics rail. Begin tightening the Thumb Nuts (clockwise) against the Rail
Clamp to secure the scope to the firearm.
4. Check and verify that the scope is firmly secured and properly mounted onto your firearms
optic rail. Check to see if the scope is position correctly on the firearm’s rail, so when it’s
shouldered that the scope is at a comfortable distance from a proper cheek weld and that you
have a full field of view through the scope.