Renkus-Heinz ICL-FR - Manual (Page 74)

74
T e c h n i c a l S p e c i f i c a t i o n s
Sensitivity:
Freq. Range:
Max SPL:
Horiz. Dispersion:
Vert. Opening Angles:
Aiming Angle:
Typical Throw:
Beam Control:
№. Transducers
-Each ICL-FR Module:
ICL-FR-LM:
№. Amp. Channels:
Dimensions:
Weight:
Hardware:
Enclosure:
Inputs:
Controls (Rear Mounted):
Computer Controls:
Status Indicators:
Power Connector:
Finish:
Network Digital Format:
DSP/AMPLIFIER
Type:
Input Impedance:
Max Input
Power Rating:
Freq. Range:
THD Distortion:
Hum & Noise:
Power Required:
(per module)
1.0 V (for rated power output)
80 Hz to 20 kHz
ICL-FR:105 dB peak @ 100 Ft. (30.5 m),
ICL-FR-DUAL & ICL-FR-TRIP:108 dB peak
(3-octave bandwidth centered at 2 kHz)
150° up to 3 kHz; 120° above 3 kHz
ICL-FR: 20°, 25° and 30°
ICL-FR-DUAL & ICL-FR-TRIP: 5°, 10°, 15° and 20°
Adjustable from -30° to +30°
ICL-FR: 80 Ft. (25 meters)
ICL-FR-DUAL & ICL-FR-TRIP: 160 Ft. (50 meters)
ICL-FR: Effective down to 800 Hz
ICL-FR-DUAL: Effective down to 400 Hz
ICL-FR-TRIP: Effective down to 250 Hz.
Five 6.5-inch cone transducers & Three 1-inch HF drivers
Seven 6.5-inch cone transducers
8 per module
ICL-FR: 48” H x 8” W x 7” D (121.5 cm x 20. cm x 17.8 cm)
ICL-FR-DUAL: 95” H x 8” W x 7” D (2431.5cm x 20. cm x 17.8 cm)
ICL-FR: 61 Lbs (27.7 Kg) ; ICL-FR-DUAL: 122 Lbs (55.4 Kg)
ICL-FR-TRIP: 174 Lbs (55.4 Kg)
Metric M10 attachment points and hinge kits
Finnish Birch with perforated steel grille
Analog Audio: 2 inputs (primary & secondary), Phoenix 3-pin connectors (looping 3-in, 3-out)
CobraNet: Dual RJ45 connectors (for CAT 5 copper cable)
AES/EBU: Phoenix connector
Mute button; Up & Down Output Level buttons; 10 dB pad (on Analog 1 input); Push-To-Reset circuit
breaker; Preset Configuration Selector (10 configurations)
Gain; Mute; On/Standby; Input Selection; Compression; 8-Band Parametric EQ; Shelving & roll off
Filters; Delay; Preset Configuration Selection
Power, Signal, Overdrive, Thermal, Mute, Input Pad, Preset Configuration Readout
IEC power connectors
Standard finish: white or black paint
Optional finishes: custom color paint, weather resistant
16 or 24 bit PCM; 48 or 96 kHz sample rate; selectable network latency.
8-channel, Class D amplifier/DSP processor
>20K Ohm balanced differential
+24 dBu (Pad in);+14 dBu @ 1 V sensitivity (Pad out)
100 Watts RMS per channel, 150 Watts Burst
+ 3, - 3 dB, 80 Hz to 20 kHz
< 0.05% typical
<100 dB (A weighted)
Universal 90/260 V AC, 50/60 Hz.
24 VA Idle; 500 VA @ rated output per module
Users Manual
ICL-FR