Renkus-Heinz ICL-FR - Manual (Page 5)

If ypu also purchased a mounting hinge kit for th column array
Attach the heavy joining plate from its hardware package to the
rear of the cabinet using the machine screws provided with the
hardware. See below. Tighten the screws loosely to allow a little
movement while joining the two modules.
Then plug one end of the flat wire signal cable into the socket
provided. It only goes into the socket one way and the cable is
reversible. It does not matter which end goes into which module.
Using a #1 Phillips screw driver, scarefully ecure the connector
with two 4-40 Phillips head screws (supplied). Make sure the
connector is fully seated.
5
Users Manual
ICL-FR
If you purchased several ICL-FR and ICL-FR-LM arrays separate-
ly and now want to turn them into a dual or triple array, you will
also need one or two ICL-F-KIT-UP joining kits. Each kit includes
two heavy metal joining plates and a short flat wire signal cable
with connectors on each end.
The first assembly step is to remove the top of both ICL-FR mod-
ules. To remove the top, remove the eight machine screws from
each side of the cabinet and lift the end piece and its mounting
brackets out of the cabinet as shown.
The next step is to install the two heavy joining plates They will
be packed with the hardware, if you ordered them as part of an
ICL-FR-DUAL or ICL-FR-TRIP..
Note: The graphics that follow show the two joining plates
mounted in one cabinet. In actual practice, it is better to mount
one plate in one cabinet and the other in the second cabinet. They
should be attached to the side where the small db15 signal cable
connector is located. This reduces the possibility of damaging the
connector while sliding the two cabinets together.
Use the mounting bracket machine screws you removed to install
the two heavy joining plates .Tighten the screws lightly. The
joining plates need to be a little loose to slide easily into the other
cabinet.