Stuart Turner Submersible Supersub VA - Manual (Page 7)

- 7 -
PIPEWORK
WARNING
Ensure pipework from pump is independently supported to prevent forces
being transferred to outlet branch .
General
All models are supplied with a 90 o elbow and stepped hose connector (see pump
connection section for details) which can be screwed directly into the pump discharge
connection .
The hose connector is suitable for a range of flexible hose sizes and can be cut to suit
the selected size . For best flow use the largest bore pipe possible minimising 90° bends .
Small pipe sizes will reduce the pump performance .
The discharge pipework must be independently supported to prevent forces being
transferred to the pump outlet branch .
ELECTRICAL INSTALLATION
WARNINGS:
z
The electrical installation must be carried out in accordance with the
current national electrical regulations and installed by a competent
person .
z
A residual current device having a rated current not exceeding 30 mA
MUST be installed in the supply circuit . This may be part of a
consumer unit or a separate unit .
z
Before starting work on the electrical installation, ensure the power
supply is isolated .
z
This appliance must be earthed .
z
Isolate all appliances in the water from the electrical supply before
putting your hands in the water .
z
The power supply cord of this pump cannot be replaced . If the cord is
damaged, the pump should be scrapped .
z
If the pump is used to empty a swimming pool, the pump must not be
used when people are in the water .
All motors are thermally protected by an integral auto-resetting thermotrip and are rated
for continuous use .
Earthing
This appliance must be earthed via the supply cord .
Cont . . .