MAHLE RTI MCX-2 - Manual (Page 9)

Page 8
Hose
Radiator
Radiator
SYS TEM PRE SSU RE
DRA IN SYS TEM
OFF
ON
OFF
OFF
ON
TES T FILL FILL SYS TEM
SYS TEM VA CUU M
ON
EM PTY WAS TE
Green Hose
Black Hose
Water
Pump
Overflow
Step
Adapters
Engine
Block Heater
Core
Connecting at Engine
Adapter
Hose
Block
Engine
Connecting at Radiator
Hose
Black Hose
Adapter
Hose
SYS TEM PR ESS UR E
DR AIN SYS TEM
OFF
ON
OFF
OFF
ON
TES T FILL FILL SYS TEM
SYS TEM VA CU UM
ON
EM PTY WAS TE
Overflow
Step
Radiator
Adapters
Water
Pump
Green Hose
Radiator
Heater
Core
CONNECTING TO THE COOLANT SYSTEM
The MCX-2 can be connected to the cooling system in either of the configurations
shown below. The choice is dependent on the ease of accessability to the hose
connections.
1. Disconnect the radiator hose from either the engine or the radiator.
2. Select an Adapter Hose with the same inner diameter as the radiator hose and
connect at the point the radiator hose was disconnected using a clamp.
3. Install Step Adapters in the Adapter Hose and the radiator hose using clamps.
Make sure the outside diameter of the Step Adapters is the same as the inner
diameter of the radiator hose.
4. Connect the Green and Black hoses from the MCX-2 to the two Step Adapters
as shown in the illustrations. BE CAREFUL - GET THEM RIGHT !!!!
5. Open the valves on the two Step Adapters.